PRODUCTION OF ALKALI USING LOCAL RAW MATERIAL (PALM INFORESCENCE)

ABSTRACT
The project aims to develop a flow process to obtain the optimum temperature and time necessary for the maximum recovery of alkali present in palm inflorescence. On this ground, a preliminary experiment was performed.  During this process, both male and female palm inflorescence were compared for maximum alkali production and it was observed that the female palm inflorescence produced highest quantity of alkali than the male palm inflorescence.  Based on this, the female palm inflorescence was used in performing the experiment. Also, experiments were carried out to determine the optimum temperature and time for maximum alkali recovery.  After the analysis and analytical calculations it was found that the optimum temperature for maximum alkali production is 4500c and the corresponding time for the production is 90 minutes.
TABLE OF CONTENT Title page Letter of transmittal Dedication Acknowledgement Abstract Table of content
CHAPTER ONE 1.0  INTRODUCTION 1.1  Need for local production of Alkali
CHAPTER TWO 2.0    LITERATURE REVIEW 2.1    Oil palm tree (description)  2.1.1 Classification of palm and location 2.1.2 Oil palm: Historical review 2.2    Palm inflorescence
CHAPTER THREE 3.0    Experimental procedure
CHAPTER FOUR 4.0   Experimental results
CHAPTER SIX Conclusion
CHAPTER SEVEN Recommendation References 
CHAPTER EIGHT Appendixes