Development of Laboratory Hot Compression Mounting Press Machine

Abstract.

This research focuses on the design, fabrication and performance evaluation of a laboratory hot 

mounting press machine for metallography using locally sourced materials and indigenous 

technology. To achieve this research objective, working drawings were produced which were used 

to produce the parts of the machine. Mild steel plates were used for the housing and the movable 

platen while stainless steel and mild steel rods were used for the production of the mold and the 

sturd respectively. From the design, the temperature of 180°C was used to melt resin by heat 

supplied from band heater and heating time was 10 minutes. The pressure of 28 MPa was applied 

by the hydraulic jack for the resin. The need to produce a user friendly and low cost laboratory 

mounting press machine using indigenous technology and locally sourced materials led to this 

study and hence, this research is recommended for use in metallurgical sectors, tertiary institutions 

and research institutes such as The National Agency for Science and Engineering Infrastructure 

(NASENI), Engineering Materials Development Institute (EMDI), Abuja, and National Board for 

Technological Incubation (NBTI).