CONSTRUCTION OF REMOTE CONTROL SWITCH

TABLE OF CONTENT:
CHAPTER ONE
INTRODUCTION 1.1     OBJECTIVE OF PROJECT 1.2     JUSTIFICATION OF PROJECT 1.3     SCOPE OF DIAGRAMS IN PROJECT 1.4     BLOCK DIAGRAM OF PROJECT 1.5     PROJECT  REPORT ORGANIZATION
CHAPTER TWO LITERATURE REVIEW 2.1     REVIEW OF REMOTE CONTROL SYSTEMS 2.2     DESCRIPTION OF PROJECT  2.3     USE OF PROJECT
CHAPTER THREE METHODOLOGY 3.1       INFORMATION GATHERING 3.2       HARDWARE COMPONENTS ANALYSIS 3.2.1    Transformers 3.2.2    Bridge Rectifier 3.2.3    Diodes 3.2.4    Capacitors 3.2.5    Voltage Regulator 3.2.6    Light Emitting Diode 3.2.7    Resistors 3.2.8    MICROCONTROLLER 3.2.9    CRYSTAL OSCILLATORS 3.2.10  TRANSISTOR 3.2.11   RELAYS 3.2.12   INFRA RED TRANSMITTERS AND RECEIVERS 3.3       SYSTEM DESIGN APPROACH 3.4       CHOICE OF DESIGN 3.5       THE PROCESS FLOW CHART
CHAPTER FOUR DESIGN 4.1       THE HARDWARE SUBSYSTEMS 4.1.0     Basic Power Supply Design 4.2        Microcontroller (AT89C51) 4.3        THE INPUT INTERFACE DESIGN 4.4        THE OUTPUT INTERFACE DESIGN 4.5        CONTROL SOFTWARE PROGRAM DESIGN
CHAPTER FIVE SYSTEM TESTING, IMPLEMENTATION AND EVALUATION 5.1       SYSTEM TESTING  5.1.0     Test Plan 5.1.1     Test Data 5.2        CHOICE OF PROGRAMMING LANGUAGE 5.3       EXPECTED TEST RESULTS 5.4        PERFORMANCE EVALUATION
CHAPTER SIX SUMMARY AND CONCLUSION 6.1     SUMMARY 6.2     PROBLEMS ENCOUNTERED 6.3      CONCLUSION              REFERENCES              APPENDIX A              APPENDIX B