CONSTRUCTION OF INDUSTRIAL BARROW

ABSTRACT The constructional project involved the construction of an industrial barrow of standard size was constructed. The process used went across various Engineering practice. These involved the procurement of galvanized steel of 0.00mm to 300mm thickness. Some galvanized steel rods and pipes were also used for the construction.  The Engineering drawing was done followed by the following operation: Marking out, cutting, bending and folding. Finally, the construction of an industrial barrow was done successfully and clean, portable and standard industrial barrow was obtained. These industrial barrows can be used in material handling activities.
TABLE OF CONTENTS
Title page  Dedication  Acknowledgement  Letter of posterity / Transmittal  Abstract  Content 
CHAPTER ONE  1.0Introduction  1.1Origin and History  1.2Aim 
CHAPTER TWO  Literature review 
CHAPTER THREE  3.0Sequence of operation  3.1Prototype construction  3.2Operation description  3.3Material analysis  3.4Testing of construction and analysis  3.5Testing and results. 
CHAPTER FOUR  4.0Cost evaluation  4.1Cost of standard wheel 
CHAPTER FIVE  Discussion 
CHAPTER SIX  Recommendation  Conclusion 
CHAPTER SEVEN  Bibliography